Researching Maintenance; Equipment and Irrigation
Spark plug metals Is there an advantage to using high-end spark plugs made out of special metals vs. the standard, less-expensive models?-Texas (via the internet)
You’re probably referring to platinum- or gold-tipped spark plugs. You are most likely better off using the standard carbon plugs in your grounds maintenance equipment. Oil inevitably gets into the cylinders of mower and hand-held-equipment engines and contaminates (to some degree) the spark plug’s tip. The platinum- and gold-tipped plugs cannot burn off this oil, and soon perform inadequately. Standard, carbon spark plugs readily burn off the small amounts of oil contaminants (specialtyplugs don’t do this) in your hand-held equipment and remain an adequate component.
Additionally, split-tipped (called “split-fire”) spark plugs are available. These plugs have two sharp points (sharp points attract sparks better) instead of one. It is true that split-tip spark plugs offer a better spark, but they wear down after 40 or 50 hours. After this, you have a single-point spark plug though you probably assumed the split tip would last much longer.
Leaky gaskets On some of my older equipment, oil is seeping through the head gaskets. Can I just tighten the head bolts to put more pressure on the gaskets? It seems like this would help, but it would mean exceeding the manufacturer’s specs.-Arkansas (via the internet)
Don’t ever over-tighten head bolts. Not only will you worsen the leak, you could stretch or strip the threads on the bolts or break them. Gasket replacement often is your only remedy. If your head bolts have been over-tightened in the past, your equipment may have permanent damage that prevents a new gasket from completely sealing. In this case, leaks will continue. Always maintain your equipment within the manufacturer’s recommendations. Failure to do so may damage your equipment and void warranties.
COPYRIGHT 1999 PRIMEDIA Business Magazines & Media Inc. All rights reserved.
COPYRIGHT 2004 Gale Group